Bosch Rexroth CS 440RC - Page 4

4/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
12.4 Setting the “Maximum” Blast Rate 42
12.5 Blast Rate Setting the “Closed Loop” 42
13
1313
13 Operator Option Configuration
Operator Option ConfigurationOperator Option Configuration
Operator Option Configuration 43
4343
43
13.1 Presetting the Gate Opening 43
13.2 Presetting the Material Selection 43
13.3 Presetting the Pre-wet Selection 44
13.4 Setting the Operator Options 44
13.5 Resetting the Season Total 44
14
1414
14 High Speed Alarm Set
High Speed Alarm SetHigh Speed Alarm Set
High Speed Alarm Set-
--
-up
upup
up 45
4545
45
14.1 Setting the High Speed Alarm 45
15
1515
15 Temperature Sensor Configuration
Temperature Sensor ConfigurationTemperature Sensor Configuration
Temperature Sensor Configuration 46
4646
46
15.1 Selecting the Temperature Sensor Manufacturer 46
15.2 Temperature Compensation 46
16
1616
16 Error Message Configuration
Error Message ConfigurationError Message Configuration
Error Message Configuration 47
4747
47
16.1 Operational Errors 47
16.2 Inputs and Outputs Errors 47
16.3 Error Time Delay 48
16.4 Error Action 48
17
1717
17 Frequently Asked Questions (FAQs)
Frequently Asked Questions (FAQs)Frequently Asked Questions (FAQs)
Frequently Asked Questions (FAQs) 50
5050
50
17.1 CS-440RC 50
17.2 Hydraulic 56
Bosch Rexroth Canada Corp. reserves the right to revise this information at any time and for
any reason and reserves the right to make changes at any time, without notice or obligation, to
any of the information contained in this piece of literature.
Please check for updates at: www.boschrexroth.ca/compu-spread