Bosch Rexroth CS 440RC - Calculating Spreading Time from Reports; Total Time Meaning in Event Reports; CS-440 RC Error Codes and Messages; Trip Summary Total Distance Units

51/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
Spin Rate
Spinner Rate, normally % output
Headers
HeadersHeaders
Headers
Meaning
MeaningMeaning
Meaning
Ctrl Mode
Conveyo
r control mode
Gate/Error
Gate position in inches, and error code
Temp.
Temperature
2. What is the spreading
2. What is the spreading2. What is the spreading
2. What is the spreading time for an event in reports?
time for an event in reports? time for an event in reports?
time for an event in reports?
Total Spread Time = Total Time - Blast Time - Pause Time.
3.
3.3.
3. Does the Total Time equal to
Does the Total Time equal to Does the Total Time equal to
Does the Total Time equal to the difference between the start times of the
the difference between the start times of the the difference between the start times of the
the difference between the start times of the
present event and the next event?
present event and the next event?present event and the next event?
present event and the next event?
The only exception being in the case of a reboot, which will show up as an INIT
event.
4. What are the CS
4. What are the CS4. What are the CS
4. What are the CS-
--
-440RC
440RC 440RC
440RC error codes and error messages?
error codes and error messages?error codes and error messages?
error codes and error messages?
• 01 – Under-Application of Solid
• 02 – Under-Application of Liquid
• 03 – Output Non-Zero on a start up
• 04 – Blast too long
• 05 – Over Speed Warning
• 06 – Sensor Calibration Error
• 09 – Knob Input Failure
• 10 – PWM Output Failure
• 11 – MC08 System Error
• 12 – No Solid Material
• 13 – No Ground Speed
• 14 – No Conveyor Sensor
• 15 – No Flow Sensor
• 16 – No Gate Sensor
• 17 – Leaving Ground Speed Simulation mode, warning only
• 18 – Gate Position is zero, warning
• 20 – No communication between display and RC
5.
5.5.
5. Why does units of Total Dist. Trip Summary togg
Why does units of Total Dist. Trip Summary toggWhy does units of Total Dist. Trip Summary togg
Why does units of Total Dist. Trip Summary toggle between km/mi and pls?
le between km/mi and pls?le between km/mi and pls?
le between km/mi and pls?
This field shows both Total Dist. in km/mi or Dist. in pulses. The field toggles
between two values each time Trip Summary is accessed. The feature can be used
to count pulses for a designated distance, which is one way to set up GROUND
SPEED input.