Bosch Rexroth CS 440RC - Checking Conveyor;Spinner;Prewet;Gate Modes; Default System Password; Setting Up and Using Simulated Ground Speed; Understanding BLAST Mode Options

52/57
Bosch Rexroth Canada ı 03.10.2011 ı Revision 5.4
6.
6.6.
6. How to check the Conveyor/Spinner/Prewet/Gate Operation modes?
How to check the Conveyor/Spinner/Prewet/Gate Operation modes?How to check the Conveyor/Spinner/Prewet/Gate Operation modes?
How to check the Conveyor/Spinner/Prewet/Gate Operation modes?
The Conveyor mode and Material selected are shown on the top left Operator
Screen as: X-MAT001
• X: A-Automatic/Closed, O-Open, M-Manual, C-Wt/Area
• MAT001: Name of the Material selected
The Prewet mode and Liquid selected are shown on the top right Operator Screen
as: X-LIQ001
• X: F-Fixed, V-Variable, M-Manual
• LIQ001: Name of the Liquid selected
If the Gate Read Back is on a ‘R’ is added after the gate position, for instance, ‘Gate:
04 R’.
7.
7.7.
7. What is the default PASSWORD?
What is the default PASSWORD?What is the default PASSWORD?
What is the default PASSWORD?
‘CS-440RC’ is the factory default password.
8.
8.8.
8. What is the Simulated Ground Speed and how to set up?
What is the Simulated Ground Speed and how to set up?What is the Simulated Ground Speed and how to set up?
What is the Simulated Ground Speed and how to set up?
It simulates the ground speed signal, and to allows for diagnostics and calibration
without moving. To set it up, here are the steps:
• Set to program mode by turning the programming key
• Select SYSTEM SETUP->SPD SIM+ANTI-ICING->SPD SIM
• Press ENTER key
• Set back to operation mode
• Press ESC to show operator screen
• Scroll Up/Down to adjust ground speed
9.
9.9.
9. What are the m
What are the mWhat are the m
What are the modes for BLAST?
odes for BLAST?odes for BLAST?
odes for BLAST?
• MAX OUTPUT, set to max valve output
• STATIONARY MAX, set to max valve output irrelevant of ground speed
• CLOSED LOOP, regulate to the configured BLAST rate
• OFF
10.
10.10.
10. How does the SOLID REDUCTION work?
How does the SOLID REDUCTION work?How does the SOLID REDUCTION work?
How does the SOLID REDUCTION work?
It designed to reduce salt usage by a pre-configured percentage when PREWET is
used. Here are the steps to set up:
• Turn the key to program mode
• Select SYSTEM SETUP->OPERATION SETTINGS->SOLID REDUCTION
• Set a percentage of reduction for each material
11.
11.11.
11. What is the RETURN OIL PREWET?
What is the RETURN OIL PREWET?What is the RETURN OIL PREWET?
What is the RETURN OIL PREWET?