EasyManuals Logo

Bosch rexroth HyDrotrAC GFt User Manual

Bosch rexroth HyDrotrAC GFt
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
RE 79094, Issue 10.2019, Bosch Rexroth AG
Transport and storage | HYDROTRAC GFT >130 kNm 23/64
f Choose the chain or cable length such that the attachment angle remains smaller
than 90°.
f Please ensure that the mounting parts attached depending on the gearbox
design cannot be damaged by transport elements when the planetary gearbox is
lifted.
f Always load the planetary gearbox on a load-bearing surface as shown in the
gure beside.
6.2 STORING THE HYDROTRAC GFT
NOTE
Risk of damaging the planetary gearbox!
A planetary gearbox stored for more than 12 months has to be thoroughly
inspected and submitted to a test run before use!
f If necessary, contact our Rexroth Service before installing a planetary gearbox
that has been stored for more than 12 months.
f This product should only be tested by qualied personnel (refer to chapter
2.4“Qualication of personnel”).
Preservation and storing of the planetary gearbox is described in this chapter.
For queries concerning preservation and storage, please contact a Rexroth's
subsidiary located near you or the main plant directly. For the addresses of our
national agencies, refer to www.boschrexroth.com/addresses and the address
directory in appendix A“Address directory” of the material number-specic
operating instructions.
6.2.1 Preservation
Rexroth delivers the planetary gearbox without oil lling. The planetary gearbox is,
however, preserved from the inside with e.g. Ri Chan Jia HE L-HL15.
The external ange surfaces and anging surfaces are applied with preservative by
the factory (e.g. PERIGOL VCI 230 or CUSTOS 10-38).
After removing the packing, you must check whether the outside preservation is still
correct.
f If the preservation is damaged and gearbox parts on the outside have bright
spots, then preserve these spots again with e.g. PERIGOL VCI 230 or
CUSTOS 10-38.
f Observe the manufacturer's product data sheets and safety data sheets when
using preservative. These data sheets are not included within Rexroth's scope of
supply.
CORRECTION COPY 1 |17.10.2019 | ONLY FOR INTERNAL USE

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch rexroth HyDrotrAC GFt and is the answer not in the manual?

Bosch rexroth HyDrotrAC GFt Specifications

General IconGeneral
BrandBosch
Modelrexroth HyDrotrAC GFt
CategoryDC Drives
LanguageEnglish

Related product manuals