Bosch rexroth HyDrotrAC GFt - Commissioning; Initial Commissioning

RE 79094, Issue 10.2019, Bosch Rexroth AG
Commissioning | HYDROTRAC GFT >130 kNm 37/64
8 Commissioning
WARNING
Dangers caused by work in the danger zone of a machine/vehicle!
Mortal danger, risk of injury or severe physical injury!
f Be aware of potential hazards and eliminate such hazards before taking the
planetary gearbox into operation.
f Nobody should be in the danger zone of the machine or the vehicle.
f The “Emergency Stop” button for the machine/vehicle must be within reach of
the operator.
f Necessarily observe the information provided by the machine or vehicle
manufacturer during commissioning.
CAUTION
Commissioning an improperly installed product!
Risk of injury and property damage! Improperly installed products may cause
injuries or damages to the product!
f Make sure that all electrical or hydraulic connections are connected or sealed.
f Only commission a completely installed product.
8.1 INITIAL COMMISSIONING
Before commissioning the planetary gearbox, following documents must be at hand:
• Dimensioned drawing of the planetary gearbox
• Technical data of the planetary gearbox
f Only commission the planetary gearbox if it has been mounted and installed
according to the instructions and information in these operating instructions, the
material number-specic operating instructions and the operating instructions of
the overall machine or the vehicle.
For all work related commissioning of the planetary gearbox, observe the
general safety instructions and intended use as specied in chapter 2 “Safety
instructions”.
CORRECTION COPY 1 |17.10.2019 | ONLY FOR INTERNAL USE