Bosch rexroth HyDrotrAC GFt - Installation Position; Required Tools

RE 79094, Issue 10.2019, Bosch Rexroth AG
Assembly | HYDROTRAC GFT >130 kNm 27/64
7.3 INSTALLATION POSITION
The installation position of the planetary gearbox is horizontal.
The planetary gearbox installation position approved and recommended by
Rexroth is indicated on the dimensioned drawing in appendix D “Technical data
/ Drawings” of the material number-specic operating instructions.
NOTE
Installation of the planetary gearbox in a non-approved Rexroth mounting
position!
Damage or failure of the planetary gearbox and expiry of the warranty!
f Only install the planetary gearbox in an approved Rexroth mounting position
as indicated in the dimensioned drawing in appendix D “Technical data /
Drawings” of the material number-specic operating instructions.
Damage to the planetary gearbox through misalignment with the machine frame!
Property damage!
f Do not tilt the planetary gearbox during installation and insert it into the
machine frame torsion-free and tension-free.
f Avoid misalignment of the planetary gearbox during installation.
f Align the gearbox exactly with the machine or chassis frame.
7.3.1 Operation with axial-piston motor (if included within the scope of supply)
f It is essential to observe the instructions in the operating instructions of the
axial-piston motor. For the instructions, please refer to chapter C "Mounting
parts" of the material number-specic operating instructions.
7.4 REQUIRED TOOLS
The planetary gearbox can be assembled with standard tools. No special tool is
required.
CORRECTION COPY 1 |17.10.2019 | ONLY FOR INTERNAL USE