Bosch rexroth HyDrotrAC GFt - Assembling the Gearbox; Preparing for Assembly

28/64 HYDROTRAC GFT >130 kNm | Assembly
Bosch Rexroth AG, Issue 10.2019, RE 79094
7.5 ASSEMBLING THE HYDROTRAC GFT
The required, proper assembly sequence depends on the machine or chassis frame
design and may therefore differ from the assembly sequence described in these
operating instructions.
7.5.1
Preparing assembly
1. Check if the scope of supply is complete and shows transport damages. Refer to
your material number-specic operating instructions for the complete scope of
supply.
2. Compare the material number and the type designation on the nameplate with
the details in the order conrmation or on the delivery note. If the material
number of the planetary gearbox does not match the order conrmation or the
delivery note, please contact the Rexroth Service.
3. Compare the connecting dimensions of planetary gearbox and chassis or
equipment frame.
4. Compare the connecting dimensions of the planetary gearbox with the sprocket
(Turas) or the rim.
The mounting order depends on the machine, the vehicle or the chassis or
equipment frame design. Refer to the instructions in chapter 7.2 “Installation
conditions”. In addition, observe the assembly instructions of the machine or
vehicle manufacturer.
The dimensioned drawing contains the dimensions of all connections of the
HYDROTRAC GFT planetary gearbox. Also observe the instructions of the
manufacturers of the mounting parts in appendix C “Mounting parts” in the
material number-specic operating instructions.
5. Remove the preservative from the outside ange surfaces with a suitable
organic solvent (e.g. HAKUTEX 74) or an alkaline detergent
(e.g. HAKUPUR 236). Wear suitable protective gloves and protective goggles
when cleaning the planetary gearbox and observe the manufacturer's safety
notes when handling preservative or solvents. These data sheets are not
included within Rexroth's scope of supply.
Procedure
CORRECTION COPY 1 |17.10.2019 | ONLY FOR INTERNAL USE