32/64 HYDROTRAC GFT >130 kNm | Assembly
Bosch Rexroth AG, Issue 10.2019, RE 79094
7.5.3 Connecting the axial-piston motor of the planetary gearbox to the
hydraulic system
The machine or vehicle manufacturer is responsible for laying the lines. The
axial-piston motor or the static multiple-disk parking brake (parking brake) has
to be connected to the hydraulic system according to the machine or vehicle
manufacturer's hydraulic diagram.
CAUTION
Failure or damage to the planetary gearbox!
Operation of the axial-piston motor without reading the general operating
instructions of the axial-piston motor rst or observing the hydraulic diagram of
the machine or vehicle manufacturer may cause damage to the axial-piston motor/
planetary gearbox/machine or vehicle!
f For installation of the axial-piston motor, please refer to the general operating
instructions in chapter C “Mounting parts” of the material number-specic
operating instructions.
f Observe the hydraulic diagram of the machine or vehicle manufacturer.
7.5.4
Installing the planetary gearbox with axial-piston motor connection
(axial-piston motor is not included in the scope of supply)
CAUTION
Failure or damage to the planetary gearbox!
If you install the planetary gearbox in any other installation position than the one
permitted by Rexroth, the planetary gearbox may be damaged or fail. The warranty
claim lapses!
f Only install the planetary gearbox in an approved Rexroth mounting position
as indicated in the dimensioned drawing in appendix D “Technical data /
Drawings” of the material number-specic operating instructions.
f Observe the operating instructions of the axial-piston motor manufacturer (not
included within the scope of supply). This is where you will nd all the required
information on assembly and commissioning of the axial-piston motor.
If the planetary gearbox is delivered without the axial-piston motor, install as follows:
• Assemble the planetary gearbox to the machine or chassis frame. In addition,
observe chapter 7.5.1 “Preparing assembly”.
• Then assemble the axial-piston motor to the planetary gearbox.
Assembling the planetary gearbox at/into the machine or chassis frame.
1. For installation, strictly observe the corresponding data in the dimensioned
drawing of the planetary gearbox in appendix D“Technical data / Drawings” of
the material number-specic operating instructions.
2. Also observe the primary operating instructions of the machine or vehicle and
the manufacturer’s frame drawing.
3. For the planetary gearbox weight, refer to appendix D “Technical data /
Drawings” of the material number-specic operating instructions.
Procedure
CORRECTION COPY 1 |17.10.2019 | ONLY FOR INTERNAL USE
To Next Page
Loading...
