RE 79094, Issue 10.2019, Bosch Rexroth AG
Disassembly and replacement | HYDROTRAC GFT >130 kNm 59/64
12.4 PREPARING THE PLANETARY GEARBOX FOR STORAGE
REUSE
This chapter only describes how to prepare the planetary gearbox for storage reuse.
For queries, please contact a Rexroth's subsidiary located near you or the main
plant directly. For the addresses of our national agencies, refer to www.
boschrexroth.com and the address directory in appendix A“Address
directory” of the material number-specic operating instructions.
1. Carefully close all the openings of the planetary gearbox.
2. Clean the planetary gearbox as described in chapter 10.1 “Cleaning and Care”.
3. For preservation, ll the planetary gearbox with lubricating oil approved for
this planetary gearbox. See selection list– industrial gear oils in appendix B
“Required and supplementary documentations” in the material number-specic
operating instructions. Fill the planetary gearbox as described in chapter
8.1.3 “Filling the planetary gearbox with lubricating oil” in these operating
instructions.
4. Preserve the surfaces of external anges, shaft ends and ange surfaces with a
preservative (e.g. PERIGOL VCI 230 or CUSTOS 10-38). Observe chapter 6.2.1
“Preservation” and the associated product data sheets and safety data sheets.
5. Store the planetary gearbox as described in chapter 6 “Transport and storage”.
CORRECTION COPY 1 |17.10.2019 | ONLY FOR INTERNAL USE
To Next Page
Loading...
