The default user ID is:
● User name: boschrexroth
● Password: boschrexroth
Fig. 12-3: "Welcome" dialog
12.8.1 Hardware data
The "Hardware" site lists all device-specific data of the IndraMotion MLC based
on the hardware IndraControl VPB in a table.
● Material index
● Hardware type plate
● Serial number
● Part number
12.8.2 Network settings
The "Network" site is used to configure the network settings for the interface
XETH2. The currently configured network settings are shown in the following
three fields and can also be changed using these fields:
● IP address
● Gateway
● Subnet mask
Enter a valid network setting and write that setting to the control (press the
Write configuration button). If writing the network settings is completed
successfully, a message is displayed in the header area of the site. The Reboot
control button is additionally displayed. It is used to restart the control and thus
applies the network setting.
Bosch Rexroth AG
Device description
IndraControl VPB 40.4
50/87
DOK-MLC***-INDRACTRLV4-IT02-EN-P
To Next Page
Loading...
