● UL508 (Industrial Control Equipment)
● C22.2 no. 142-M1987 (CSA)
UL file no. E210730
However, there can be combinations or extension stages with a limited or
missing certification. Thus, verify the registration according to the UL marking
on the device.
Loss of UL/CSA conformity due to modifications at the device
UL and CSA marking applies only to the device upon delivery. After
modifying the device, verify the UL and the CSA conformity.
9 Interfaces
Material damages to electronics due to missing
functional earth!
Ensure that the functional earth is connected, as otherwise the electronics can
be destroyed by a potential difference between the operator display and the
control cabinet PC if the voltage supply is interrupted to only one device and
established again. A direct connection of the functional earth between the
operator display and the control cabinet PC is optimal. If the functional earth is
connected to a neutral point, the control cabinet PC and the operator display
have to be connected to this neutral point.
To avoid malfunctions, use only shielded cables and metallic or
conductive connector/coupling housings with large-area shield
support.
9.1 Overview
The following connections are available at the control cabinet PC:
Name at the
housing
Connection type Connection type
(at the device)
Mating connector or cable
(from outside)
X10 PC voltage supply:
24 V DC
Male connector
terminal PC4/3-
G7.62
Socket terminal
PC4/3-G7.62
XDP Connection for external monitor Display port socket,
(20-pin)
Display port plug, (20-pin)
XSER CDI interface, data RJ45 socket, 8-pin RJ45 plug
(Twisted pair, 8-wire)
XVID CDI interface, image RJ45 socket, 8-pin RJ45 plug
(Twisted pair, 8-wire)
IndraControl VPB 40.4 Bosch Rexroth AG
Interfaces
DOK-MLC***-INDRACTRLV4-IT02-EN-P
13/87
To Next Page
Loading...
