State, tooltip Icon Description
Run System firmware is loaded and ready. At least one PLC
application was started
Stop System firmware is loaded and not ready. All loaded
PLC applications are stopped
Boot stop The control startup was paused
Initial firmware is active Initial firmware is active
Errors The following erros are signaled:
● Version conflict: Version error between IndraControl
Systray and firmware
● Windows reboot or shutdown
● System firmware or initial firmware is not started
Context menu is disabled
If the error occurs again after the reboot, contact the
Bosch Rexroth service
General information General icon display, e.g. start of the SysTray
application, the control is in "System Error" mode, etc.
Tab. 12-6: Application icons
12.9.3 Dialogs
The "Diagnostics and settings" dialog is used as operating and display element
of the control. It can be operated via the switches "Run" and "Stop" in the lower
section (modes of operations).
IndraControl VPB 40.4
Bosch Rexroth AG
Device description
DOK-MLC***-INDRACTRLV4-IT02-EN-P
59/87
To Next Page
Loading...
