If there is an mPCIe module internally, a USB 2.0 device connected
to XUSB5 does not operate anymore. A possibly connected USB 3.0
device is still functioning.
9.5 Ethernet interfaces XETH1 and XETH2
The control cabinet PC can be connected to an Ethernet network via the
Ethernet interfaces XETH1 and EXTH2.
The LAN assignment under Windows to the XLAN connections at the device is
set as follows by default:
Labeling under Windows 7 Labeling at the device
Local Area Connection XETH1
Local Area Connection 2 XETH2
Labeling under Windows 10
Ethernet XETH1
Ethernet 2 XETH2
RJ45, socket, 8-pin
Type: Ethernet 10 Base-T, 100 Base-T, 1000 Base-T
Cable length: Max. 100 m
Transmission rate: 10, 100 or 1000 MBit/s
9.6 Display port XDP
At the display port (XDP), a monitor with display port interface, a DVI monitor or
an HDMI monitor can be connected (via adapter).
Display port socket, 20-pin
Max. Resolution: 4 K
The color depth and the resolution of the VDP operator display and a monitor
connected to the display port can be set in the properties of the graphic card
under "Display" on the "Color settings" page. Select the respective display under
"Select display".
These are the following assignments under "Select display":
● Digital display: VDP operator display
● Digital display 2: Monitor at the display port
IndraControl VPB 40.4
Bosch Rexroth AG
Interfaces
DOK-MLC***-INDRACTRLV4-IT02-EN-P
17/87
To Next Page
Loading...
