RTU32M Series User Guide
Brodersen A/S, Islevdalvej 187, DK-2610 Roedovre, Denmark, Tel: +45 45 35 26 27, Fax: +45 45 35 26 29, Email: sales@Brodersen.com
August 2018
4.29 DNP3 Slave – Serial Tunneling
In applications where the RTU needs to be used to provide an IP-Serial gateway, one or two of the comm ports can be setup to pass
data to/from an IP port. The ‘Network Port’ setting defines which IP port is used.
Eg. in the example below any DNP3 messages received on IP port 20005 will be retransmitted on serial port COM1. Any DNP3
messages received on COM1 will be retransmitted on IP port 20005.
Note: the DNP3 Serial Tunneling page is disabled in the early release firmware for the RTU32M (available 3Q 2018).
To Next Page
Loading...