Brother ADS-1300 - Page 230

Difficulties Cause Suggestions
A USB flash drive is inserted into the
machine.
Remove the USB flash drive.
Cannot enter the IP
address and Subnet
Mask.
(ADS-1800W)
"000.000.000.000." has already been
entered.
Press to delete the entered information, and
then enter the correct information.
The computer has
detected a USB flash
drive.
A USB flash drive is inserted into the
machine and the computer is
connected to the machine using a
USB cable.
The computer detects the USB flash drive that is
inserted into the machine. Remove the USB flash
drive so that the computer does not detect it.
I want to prevent users
from changing settings
using Remote Setup.
(ADS-1800W)
- When you turn on the Secure Function Lock or
Setting Lock, the users cannot use Remote Setup.
Other Difficulties
Difficulties
Cause Suggestions
The machine will not
scan.
A USB Type-C cable is connected to
your computer via a USB hub.
Connect the machine directly to the computer
using the USB Type-C cable. USB hubs are not
supported.
The machine is in Sleep
Mode (power save
mode).
The machine is idle and the amount
of time specified by the Sleep Mode
setting has elapsed.
Do one of the following:
• Press
.
• Press . (ADS-1800W)
• Scan using your computer.
• Open the Front Cover.
• Load your document.
• Touch the screen. (ADS-1800W)
• Insert/disconnect the USB flash drive.
• When using an AC Adapter, insert/disconnect
the USB cable from the machine or computer.
The machine does not
turn on.
The machine was plugged in within
60 seconds after being unplugged.
Wait 60 seconds, and then turn the scanner on.
The machine does not
turn on.
-OR
ADS-1300/ADS-1350W:
The machine displays
the following error.
Flashing
Off
-OR
ADS-1800W:
The Power shortage
(Code:01) message
appears on the LCD.
When powering the machine using a
USB Type-C cable, the USB Type-C
cable is not correctly connected.
Securely connect the USB Type-C cable to your
computer, turn the Brother machine off, and then
turn it on again.
The AC Adapter is not correctly
connected to the electrical socket.
Securely connect the AC Adapter to the electrical
socket, and turn the power off and on again.
When powering the machine using a
USB Type-C cable, a cable other than
the included cable is being used.
• Use the USB Type-C cable that is included with
the machine.
• Purchase the optional AC Adapter (LK-1001C).
When powering the machine using a
USB Type-C cable, the power supply
of your computer or USB port is
insufficient. (Requires a supply of 15
W output or higher)
• Use a different USB Type-C port and make sure
it is capable of supplying 15 W output or higher.
• Purchase the optional AC Adapter (LK-1001C).
225