Brother BAS-340 - [§]Optional Output

[§] Optional output
PS
<D Presser foor (R) valve
® Presser foot (L) valve
r ~- Y'{_o!!< _c! C!'!'P _v~!~!---,
1 ~ Inner clamp valve 1
: ® Option valve 1 :
:@ Option valve 2 :
l (J) Option valve 3 : ·
l@ Needle cooler valve :
L--------------------~
® +24V
.® +24V
NOTE: @to@ are options.
FValve OFF
771[1
Final stitch point
'-valve OFF
771[iJ
*The valve will always be off at the first stitch point.
-62-
[How to connect]
1) Disconnect connector P8 from pin 12 attached
on
the control box for valve output.
2) . Referring to below, connect the air solenoid
valves correctly to the pins for optional output
and for the power supply.
Optional
output 1: Corresponds to pin 5
(Optional
output 2: Corresponds to pin 6)
(Optional output 3: Corresponds to pin 7)
Power supply(+ 24V): Connect to pin 10 or 11
3) Connect the connector to the original location.
Power (11)
Optional output {5, 6, 7)
.__ __ _, Air solenoid
NOTE 1: Pin 11 for power supply can be used
commonly for three outputs.
NOTE 2: Use MOLEX 1381 ATL (143548-000)
as the connecting pin.
[How
to program]
If programming hasn't been done before:
1) Press the "P" key to go into the programming
mode.
2) Program only the stitches which will be made
before the first inner
clamp flipping.
3) Press " 7, 7, 1( or 2 or 3), L" before and after
. inner
clamp flipping.
4) >fteferring to step 2, program the stitches before
second inner clamp flipping.
5) As'in step 3, press "7, 7, 1(or 2 or 3), L" before
and after inner clamp flipping.
5) Repeat the above procedure until the final
stitch point.
If stitch programming has been done already:
1) Press the "P" key to go into the programming
mode.
2) Load the data in the floppy disk into the P-ROM
of the machine. Then, using the + and - keys,
move the frame so that the correct position for
the first inner clamp flipping is under the
needle.
3) Press " 7, 7, 1 ( or 2 or 3), L" before and after
inner
clamp flipping.
4) Using the + and- keys, move the frame so that
the second inner clamp flipping position is
under the needle.
5) As in step 3, press "7, 7, 1 (or 2 or 3), L" before
and after inner
clamp flipping.
6) Repeat the above procedure until the final
stitch point.
From the library of: Superior Sewing Machine & Supply LLC