Brother BAS-340 - Aid Mach Ine Head

IJg) Machine head
1) Place the machine head on the power table, then secure the head hinge 0 with the four bolts.
NOTE: Do not damage electrical cords.
2) Tilt the machine. Raise the head support lever @ and pass the head support shaft @) through the arm,
then tighten the set screw.
3) Set the GS spring 0 into the machine head and insert GS spring shaft (U) 0 into the hole, then tighten
the set screw.
4) Attach the belt to the pulley.
5) Return the machine head to its original position. Unlock the head support lever @. Connect each
connector
to its proper position.
-40-
From the library of: Superior Sewing Machine & Supply LLC