Brother DCP-T430W - Configure Network Settings Using the Control Panel

Home > Network > Configure Network Settings > Configure Network Settings Using the Control Panel
Configure Network Settings Using the Control Panel
Related Models: DCP-T430W/DCP-T435W/DCP-T436W/DCP-T439W
To configure the machine for your network, use the control panel buttons.
Network Settings
Function Button 1 Button 2 Instructions
Enable the One Push Method of Wi-Fi
Protected Setup
™
(WPS).
(Wi-Fi)
- Press the button three times.
Enable the PIN Method of Wi-Fi Protected
Setup
™
(WPS).
(Wi-Fi)
- Press the button five times.
Set Wireless Direct to On.
Print the Wireless Direct Information sheet.
(Wi-Fi) (Copy
Shortcut)
Press the buttons
simultaneously.
Print the Network Configuration Report.
(Wi-Fi)
Mono Copy Press the buttons
simultaneously.
Restart Wi-Fi and Wireless Direct. Use this
function to solve wireless network problems.
(Wi-Fi)
Colour Copy Press the buttons
simultaneously.
Enter Wi-Fi Mode.
For more information, see the Wi-Fi Mode
table below.
(Wi-Fi) (Stop)
Press the buttons
simultaneously.
Wi-Fi Mode
To enter Wi-Fi Mode, press (Wi-Fi) and (Stop) simultaneously.
Function
Button Instructions
Print the WLAN Report.
(Wi-Fi)
Press the button once.
Enable or disable Wireless Direct.
(Copy Shortcut)
Press the button once.
Enable or disable Wi-Fi. Mono Copy Press the button once.
Reset the network settings. Colour Copy Press and hold the button for
two seconds.
Related Information
• Configure Network Settings
114