Home > Troubleshooting > LED Patterns and Indications
LED Patterns and Indications
The LEDs on your machine's control panel light up or flash to indicate machine status.
LED Patterns
LED
Description
The LED is off.
The LED is lit.
The LED is flashing.
General LED Indications
LED
Status Description
Standby The machine is ready to print.
(Flashing slowly and
faintly)
Sleep In Sleep Mode (Power Save Mode), the machine
acts as if it is turned off, but it can still receive data.
When you send a print job, the machine wakes up.
(Flashing by intervals of
two seconds)
Warming Up (Low Temperature) The machine is warming up.
Cooling Down (High Temperature) The machine is cooling down.
(Flashing by intervals of
one second)
Busy The machine is processing a print job.
Data Remaining There is print data in the machine's memory. To
cancel the job and clear it from the machine's
memory, press (Stop).
(Flashing alternately)
Job Cancelled The machine is cancelling the print job.
Error and Maintenance LED Indications
As with any sophisticated office product, errors may occur and supply items may have to be replaced. If this
happens, your machine identifies the error or required routine maintenance and indicates this with the LEDs on
the control panel. The LED indications are explained in this table.
You can correct most errors and perform routine maintenance yourself. If you need more tips, go to your model's
FAQs & Troubleshooting page at support.brother.com/faqs.
152
To Next Page
Loading...
