Home > Network > Wireless Network Settings > Use the Wireless Network > Configure Your Machine for a
Wireless Network Using the One Push Method of Wi-Fi Protected Setup
™
(WPS)
Configure Your Machine for a Wireless Network Using the One Push
Method of Wi-Fi Protected Setup
™
(WPS)
Related Models: DCP-T430W/DCP-T435W/DCP-T436W/DCP-T439W
If your wireless access point/router supports WPS (Push Button Configuration), you can use WPS from your
machine's control panel to configure your wireless network settings.
1. Press
(Wi-Fi) three times.
The Wi-Fi LED starts flashing.
2. Press the WPS button on your wireless access point/router.
If your wireless device is connected successfully, the Power LED and Wi-Fi LED are lit.
You have completed the wireless network setup. To install the drivers and software necessary to use your
machine, go to your model's Downloads page at
support.brother.com/downloads.
Related Information
• Use the Wireless Network
120
To Next Page
Loading...
