Home > Machine Settings > Change Machine Settings from the Control Panel > Set the Machine to Power
Off Automatically Using the Machine's Control Panel
Set the Machine to Power Off Automatically Using the Machine's
Control Panel
The Auto Power Off feature can reduce power consumption. If the machine does not receive any jobs for a
certain length of time, based on your model and settings, the machine will automatically enter Power Off mode.
The machine will not go into Power Off mode if it is connected to a network, a USB cable, or Wiress Direct. The
available features and interfaces vary depending on the model.
To turn on the machine after the Auto Power Off feature has turned it Off, press
(Stop).
1. Press
(Stop) and the Colour Copy button simultaneously.
The Power LED, Paper Warning LED, and Ink LED light up for one second, and then the Power LED turns
off and the Paper Warning LED and Ink LED start flashing.
2. Press the Mono Copy button.
The Power LED and Paper Warning LED light up and the Ink LED turns off for one second, and then the
Power LED and Ink LED start flashing.
3. Press the Colour Copy button as shown in the table to set the Power Off time.
Number of button presses Setting
One time Off
Two times 20 minutes
Three times 1 hour
Four times 2 hours
Five times 4 hours
Six times 8 hours
• The setting will stay as 8 hours, even if you press the button more than six times. To change the setting
again, press (Stop), and then repeat the above steps.
• You can confirm if the correct time has been set by checking the Auto Power Off setting in Web Based
Management.
4. Press (Copy Shortcut) to complete the setup.
The Power LED flashes three times, and then it stays lit.
Related Information
• Change Machine Settings from the Control Panel
Related Topics:
• Set the Machine to Power Off Automatically Using Web Based Management
212
To Next Page
Loading...
