Home > Introduction to Your Machine > Control Panel Overview
Control Panel Overview
In this User's Guide, the colours of the control panels and buttons for the illustrations may differ depending on the
models.
>> DCP-T230/DCP-T236/DCP-T238
>> DCP-T430W/DCP-T435W/DCP-T436W/DCP-T439W
DCP-T230/DCP-T236/DCP-T238
1. (Copy Shortcut)
• Press to make a 2 in 1 ID copy.
If necessary, one of the specific copy functions can be set as a function for this button using Web Based
Management. By default, 2 in 1 ID copy is set.
• Press simultaneously with
(Stop) to access the Maintenance Mode.
2. Mono Copy
• Press to start making copies in monochrome.
• Press simultaneously with Colour Copy to start scanning documents (in colour or monochrome,
depending on the scan setting).
• Press simultaneously with
(Stop) to access the Reset Mode.
3. Colour Copy
Press to start making copies in full colour.
4. Power LED
Indicates the machine's status.
5.
(Stop) Power On/Off
• Press to stop an operation.
• Press to exit from a selected mode.
• Press
(Stop) to turn on the machine.
Press and hold down (Stop) to turn off the machine and cancel all of the remaining operations. The
Power LED flashes and stays on for a few seconds before turning itself off.
If you turn off the machine using (Stop), it will still clean the print head periodically to maintain print
quality. To prolong print head life, provide better ink efficiency, and maintain print quality, keep your
machine connected to a power source at all times.
6. Ink LED
Indicates when the machine detects an ink error or is in Maintenance Mode.
7. Paper Warning LED
Indicates when the machine detects an error or is in Reset Mode.
9
To Next Page
Loading...
