Related Information references are at the bottom of this page.
LED Status Cause Action
Tray not detected The paper tray is not completely
inserted.
Slowly push the paper tray
completely into the machine.
Paper or a foreign object is preventing
the paper tray from being inserted
correctly.
Pull the paper tray out of the
machine and remove the jammed
paper or foreign object. If you
cannot find or remove the jammed
paper, see Related Information:
Printer Jam or Paper Jam.
No paper fed The machine is out of paper or paper
is not correctly loaded in the paper
tray.
Do one of the following:
• Refill the paper tray, and then
press the Mono Copy or
Colour Copy button.
• Remove and reload the paper,
and then press the Mono Copy
or Colour Copy button.
See Related Information: Load
Paper.
The paper is not inserted in the centre
of the manual feed slot.
Remove the paper and reinsert it in
the centre of the manual feed slot,
and then press the Mono Copy or
Colour Copy button.
See Related Information: Load
Paper in the Manual Feed Slot.
The paper in the manual feed slot
does not stay straight when fed.
Using both hands, adjust the
manual feed slot paper guides to
make sure there is no gap between
them and the paper, and then
press the Mono Copy or Colour
Copy button.
See Related Information: Load
Paper in the Manual Feed Slot.
The Jam Clear Cover is not closed
correctly.
Make sure the Jam Clear Cover is
completely closed.
See Related Information: Paper is
Jammed Inside the Machine.
Paper dust has accumulated on the
surface of the paper pick-up rollers.
Clean the paper pick-up rollers.
See Related Information: Clean the
Paper Pick-up Rollers.
Paper jam The paper is jammed in the machine. Carefully remove the jammed
paper.
See Related Information: Printer
Jam or Paper Jam.
Make sure the paper guides are set
to the correct paper size.
After completing these actions,
press (Stop).
More than one sheet of paper was
placed in the manual feed slot.
-OR-
Another sheet of paper was placed in
the manual feed slot before both the
Power LED and the Paper Warning
LED light up.
Do not put more than one sheet of
paper in the manual feed slot at
any one time.
Wait until both the Power LED and
the Paper Warning LED light up to
load another sheet of paper before
153
To Next Page
Loading...
