Home > Paper Handling > Load Paper > Load Paper in the Paper Tray > Load Cut-Sheet Paper or Photo
2L Paper in the Paper Tray
Load Cut-Sheet Paper or Photo 2L Paper in the Paper Tray
• Load only one size and type of paper in the paper tray at a time.
• (DCP-T430W/DCP-T435W/DCP-T436W/DCP-T439W)When you load a different paper size in the tray, you
must change the Paper Size setting in the machine or the paper size setting on your computer.
• (DCP-T230/DCP-T236/DCP-T238)When you load a different paper size in the tray, you must change the
paper size setting on your computer.
1. If the paper support flap (1) is open, close it, and then close the paper support (2).
2. Pull the paper tray completely out of the machine.
3. Gently press and slide the paper width guides (1) and then the paper length guide (2) to fit the paper size.
4. Fan the stack of paper well to avoid paper jams and misfeeds.
Always make sure the paper is not curled or wrinkled.
19
To Next Page
Loading...
