Home > Paper Handling > Load Paper > Load Paper in the Paper Tray > Load Photo Paper in the Paper
Tray
Load Photo Paper in the Paper Tray
• Load only one size and type of paper in the paper tray at a time.
• (DCP-T430W/DCP-T435W/DCP-T436W/DCP-T439W)When you load a different paper size in the tray, you
must change the Paper Size setting in the machine or the paper size setting on your computer.
• (DCP-T230/DCP-T236/DCP-T238)When you load a different paper size in the tray, you must change the
paper size setting on your computer.
1. If the paper support flap (1) is open, close it, and then close the paper support (2).
2. Pull the paper tray completely out of the machine.
3. Gently press and slide the paper width guides (1) and then the paper length guide (2) to fit the paper size.
4. Load up to 20 sheets of photo paper with the printing surface face down.
Loading more than 20 sheets of photo paper may cause paper jams.
5. Gently adjust the paper width guides (1) to fit the paper.
Make sure the paper width guides touch the edges of the paper and the paper is flat in the tray.
22
To Next Page
Loading...
