HL-5240/5250DN/5270DN/5280DW SERVICE MANUAL
Confidential
7-19
Title & Subtitle Item to be Set Description
FONT SELECT
BROBITM=DISABLE* Disables the internal brougham
bitmap fonts of 10 and 12 pitches.
BRO FONT SELECT
BROBITM=ENABLE Enables the internal brougham
bitmap fonts of 10 and 12 pitches.
ISRFONT=DISABLE Normal mode
ISR FONT SELECT
ISRFONT=ENABLE Israel Mode
3B PRIO=LOW* The priority of selection for 300dpi
bitmap fonts is standard (=low).
Command <ESC><CR>!1T
300DPI PRIORITY
3B PRIO=HIGH The priority of selection for 300dpi
bitmap fonts is high.
Command <ESC><CR>!2T
SCAL.F=NORMAL* Only similar size fonts are selectable
as scalable is selected.
FX/XL SCALE FONT
(Setting related to the
default font and font
selected on the panel
in the EPSON/IBM
emulation.)
SCAL.F=ALL SIZE All size fonts are selectable as
scalable font is selected.
ITA=OBLIQUE* Makes upright font oblique to have
italic as scalable font is selected.
FX/XL SCALE ITA.
(Setting related to italic
of scalable font when
the EPSON/IBM
emulation.)
ITA=ITALIC SEL Uses the upright font to have italic as
scalable font is selected.
DEF PAPER=A4 Printers to be shipped to the other
area than USA and Canada have the
A4 size setting by default.
PAPER&TRAY SIZE
DEF PAPER=LT Printers to be shipped to USA and
Canada have the Letter size setting
by default.
PARALLEL MENU
CDCC BSSL=L* ACK signal is sent out before BUSY
signal goes down.
STB/ACK DELAY
CDCC BSSL=H ACK signal is sent out when BUSY
signal goes down.
REPRINT=ON* The ON/OFF setting of the reprint
function follows the setting of the
user menu.
REPRINT ON/OFF
REPRINT=OFF Turns the reprint function OFF
forcedly.
PS BINARY=ASCII* Default setting. A problem may occur
when printing the binary data though
Ctrl-T, Ctrl-C and the like are
enabled.
PS BINARY SELECT
PS BINARY=BIN Allows you to print the binary data
though Ctrl-T and the like are
disabled.
To Next Page
Loading...
Need help?
General