Brother MFC-7240 - Eject Sensor PCB ASSY

3-77
Confidential
9.42 Eject sensor PCB ASSY
(1) Remove the taptite bind B M4x12 screw to remove the develop drive earth harness.
(2) Remove the taptite cup S M3x6 SR screw and the two taptite bind B M4x12 screws.
(3) Release the two hooks to remove the main PCB shield calking ASSY.
Fig. 3-67
Assembling Note :
• When assembling the main PCB shield calking ASSY, insert the flat cable of the eject
sensor PCB ASSY into the hole of the main PCB shield calking ASSY.
• When assembling the main PCB shield calking ASSY, tighten the two taptite bind B
M4x12 screws in numerical order written on the plate.
Taptite cup S M3x6 SR
Taptite bind B M4x12
Main PCB shield calking ASSY
Hook
Hook
1
2
Develop drive earth harness
Taptite bind B M4x12