Brother MFC-7240 - Continuous Print Test (Function Code: 67)

5-28
Confidential
1.3.18 Continuous print test (Function code: 67)
<Function>
This function is used to conduct paper feed and eject tests while printing patterns.
<Operating Procedure>
(1) Press the [6] and [7] buttons in this order in the initial state of the maintenance mode.
"PAPER FEED TEST" appears on the LCD, and continuous printing starts using a grid
pattern.
(2) When the [Stop/Exit] button is pressed, the operation is canceled, and the machine
returns to the initial state of the maintenance mode.
Note:
• Test printing continues until there is no paper in the tray. When the correct operation is
confirmed, press the [Stop/Exit] button to stop printing. (Printing is resumed when paper
is loaded in the tray.)
• In the event that an error occurs during test printing, continuous printing is suspended.
(If you do not press the [Stop/Exit] button, printing is resumed when the error is cleared.)
• To clear the error, remove the error factors, and then press the [Start] button.