Brother MFC-7240 - Page 239

5-20
Confidential
 Detail description
AutoFF Time Switching of the time-out period
of the auto form feed
1 to 99 (seconds) 5
FF Suppress Switching of the FF Suppress On/Off Off
Auto LF Switching of the auto LF On/Off Off
Auto CR Switching of the auto CR On/Off Off
Auto WRAP Switching of the auto CRLF at
the print width
On/Off Off
Auto Skip Switching of the Skip at the
backend/tip of the paper
On/Off On
Left Margin Switching of the margin at the
left end
0 to 145 (columns) 0
Right Margin Switching of the margin at the
right end
10 to 155 (columns) 80
Top Margin Switching of the margin at the
upper end
0 to 2.00 (inches) 0.5
Bottom Margin Switching of the margin at the
bottom end
0 to 2.00 (inches) 0.5
Lines Number of the text lines in the
page
5 to 128 (lines) 60
Error Print Switching of the ErrorPrint of
the PostScript
On/Off On
LCD Detail description
Manual Feed
Effective for the print from the computer, or for the print of the
NetWorkConfig/TestPrint/Fontlist/Configuration from the panel. When
the tray is selected on the computer, the setting becomes effective. And
this setting is ignored.
Resolution Effective only for the print from the computer. When the Resolution is set
on the computer, the setting becomes effective. And this setting is
ignored.
Toner Sav e Effective for all print, and change the setting of the Function Menu.
However, as for the Copy, this setting becomes invalid. When the
TonerSave is set on the computer, the setting becomes effective. And
this setting is ignored.
Density Effective for the print from the computer, or for the print of the
NetWorkConfig/TestPrint/FontList/Configuration from the panel. Link the
setting of the TonerSave. Judge the both setting, and decide the density.
When the Density is set on the computer, the setting becomes effective.
And this setting is ignored.
JB-Can Time Configure the setting for until the host time-out at the Job Cancel. The
setting value is the second time scale.
Sleep Time Configure the setting for the time until shift to the Sleep Time. Change
the setting of the Function Menu.
Page Protection Configure the setting to protect the page memory, when recording in
computer. Set in the PCL-Core. There is not the influence of the memory
management problem of the MFC.
LCD Description Set value
Initial
value