Brother MFC-7240 - Page 59

2-22
Confidential
40 13
Polled by any other manufacturers' terminal while waiting
for secure polling.
2-82
40 14 Common key not registered although it needs to be used. 2-82
40 17 Invalid resolution selected. 2-82
63 02 Password not correct. 2-82
63 03 Polling ID not correct. 2-82
74 XX DCN received. 2-82
80 01 Fallback impossible. 2-82
90 01
Unable to detect video signals or commands within 6
seconds after CFR is transmitted.
2-82
90 02
Received PPS containing invalid page count or block
count.
2-82
A0 03
Error correction sequence not terminated even at the final
transmission speed for fallback.
2-82
A0 11 Receive buffer empty (5-second time-out). 2-82
A0 12
Receive buffer full during operation except receiving into
memory.
2-82
A0 13 Decoding error continued on 500 lines or more. 2-82
A0 14 Decoding error continued for 15 seconds or more. 2-82
A0 15 Time-out: 13 seconds or more for one-line transmission. 2-82
A0 16 RTC not found or carrier OFF detected for 6 seconds. 2-82
A0 17
RTC found but no command detected for 60 seconds or
more.
2-82
A0 19 No video data to be sent. 2-82
A8 01 RTN, PIN, or ERR received (sending terminal). 2-82
A9 01 RTN, PIN, or ERR sent (receiving terminal). 2-82
AA 18 Receive buffer full during receiving into memory. 2-82
B0 01 Polarity reversion detected. 2-82
B0 02 Unable to receive the next-page data. 2-82
B0 04 PC interface error. 2-82
C0 01 No common modulation mode or failed to poll. 2-82
C0 02 Unable to detect JM. 2-82
C0 03 Unable to detect CM. 2-82
C0 04 Unable to detect CJ. 2-82
C0 10 Cannot finish V. 34 negotiation or training. 2-82
C0 11 Modem error detected during V. 34 negotiation or training. 2-82
C0 20 Modem error detected during sending of commands. 2-82
C0 21 Modem error detected during receiving of commands. 2-82
C0 22 Control channel connection time-out. 2-82
C0 30 Modem error detected during sending of video signals. 2-82
Code 1 Code 2 Cause
Refer
to: