2-42
Confidential
Error code 8D
When the power switch was turned ON, the eject sensor detected paper pass or detected
that the fuser unit cover was open.
Error code 8E to 99
These errors do not usually occur in the normal use. The conceivable causes are noise
around the installation site, fluctuation of the power supply voltage, and failures in the
software.
An unidentified error occurred.
Cover is Open
Make sure there is no paper jammed inside the machine and close the Back Cover,
then press Start.
<User Check>
• Close the fuser unit cover.
• Remove the jammed paper around the back cover.
Step Cause Remedy
1
Paper eject actuator catching
on some position
Correct the position of the paper eject actuator.
2 Eject sensor PCB failure Replace the eject sensor PCB ASSY.
3 Main PCB failure Replace the main PCB ASSY.
---
<User Check>
• Turn OFF the power switch, and turn it ON again after a while.
Step Cause Remedy
1 Main PCB failure Replace the main PCB ASSY.
To Next Page
Loading...
