Name: Brother MFC-J2310
Brand: Brother
Rating: 4 (1 reviews)

Default Chapter52

Error Messages52
Communications Error54
Troubleshooting58
- Error Cause and Solutions58
- Black Ink Cartridge Reaches Service Life Time64
After Judging as no Ink by the Ink Remaining Sensor, Ink Discharged for64
- Cyan Ink Cartridge Reaches Service Life Time64
- Magenta Ink Cartridge Reaches Service Life Time64
- Yellow Ink Cartridge Reaches Service Life Time64
- No Black Ink Cartridge Loaded65
- No Yellow Ink Cartridge Loaded65
Detected by the Ink Cartridge Detection Sensor65
- No Magenta Ink Cartridge Loaded65
Cannot Communicate with Ink Cartridge IC Chip (Machine Body Side.)66
Ink Cartridge Cover Sensor Detects Opened Cover State66
Detected by the CR Encoder Sensor67
Detected by the CR Encoder Sensor68
Head Capping Is Unable68
Defective Occurs in the Carriage Motor, Paper Feed Motor71
Carriage Motor Cannot Stop72
- Casing Internal Thermistor Defective72
Error Code72
Machine Internal Thermistor Detects -20 Degree-C or Less and 80 Degree-C or72
Head Thermistor Detects -20 Degree-C or Less and 80 Degree-C or more When73
Head Voltage Does Not Turn off73
- Head Thermistor Defective73
Head Driver IC Detects Abnormal Temperature During Operation or Stand-By74
Head Flat Cable Detected to be Not Correctly Inserted74
Purge Count or Flushing Count Overflown74
Head Voltage Does Not Raise75
Ink Absorber Full Sensor Harness Detected to be Not Correctly Inserted75
Head Voltage Drops too Quick76
The Purge Cam Switch Is Not Switching ON/OFF76
Failed to Detect the Origin of the Purge Cam77
Abnormal Stop of Purge Cam Being Driven78
Excessive Current Protection Activated for the Driver IC During Pump Operation78
Pump of Maintenance Unit Stopped Abnormally During Exhaustion/Suction78
- Excessive Current Protection Activated for the Driver IC During Purge Cam Operation78
Switchback Sensor Detects no Recording Paper Tray State79
Head Property Information Not Input80
Head/Carriage Unit Cannot Shift to Head Capping Position80
Head/Carriage Unit Cannot Shift to Head Uncapping Position80
Recording Paper Width Sensor Cannot Detect Origin Specified on the Recording Paper Feed Roller84
PF Encoder Sensor Cannot Detect Rotation of the Recording Paper Feed Motor85
- Excessive Current Protection Activated for the Driver IC During Recording Paper Feed Motor Operation86
Paper Feed Motor Cannot Stop86
A2 Document Scanning Position Sensor Detects Length of Document 90 CM or more87
Document Scanner Sensor Detects that Document Scanner Is Open87
ADF Cover Sensor Detects Opened Cover State88
- Level of First Side CIS Scan Result Is Detected as Abnormal During FAX Transmission (after Re-Try.)89
- Level of First Side CIS Scan Result Is Detected as Abnormal During FAX Transmission (First Transmission.)89
A7 Type of CIS Unit and CIS Type Input Value Does Not Match89
Matching of Color Parameter Fails (for Development Debugging.)89
- Level of Second Side CIS Scan Result Is Detected as Abnormal During FAX Transmission (First Transmission.)90
AF CIS Positioning Abnormal (Home Position Cannot be Found)90
- Level of Second Side CIS Scan Result Detected as Abnormal During FAX Transmission (after Re-Try.)91
BD Black Level Value Abnormal at Scanning91
- Document Scanning Position Sensor Detects Size that Its Length Does Not Fit Duplex Scanning92
Modem Does Not Start Normally Even after Resetting the Modem92
SDAA Communication Failure92
Wired LAN MAC Address Not Registered92
LCD Disconnection Detected93
Main PCB ASSY EEPROM Write Error93
Flash File System Error94
- Paper Is Not Fed from Paper Tray95
- Recording Paper Feeding Problems95
- Paper Feeding at an Angle97
- Paper Is Not Fed from Manual Feed Slot97
- Two or more Sheets of Paper Fed at a Time97
- Recording Paper Jam98
- Prints Only Single Side of the Paper When Duplex-Printing101
- Defective Images102
- Print-Image Problems102
- Print-Image Problems103
- Cannot Print Data113
- Software-Related Problems113
- Cannot Make a Print through Network Connection114
- Network Problems114
- Control Panel Problems115
- No Display on LCD115
- No Display on LED115
- The Control Panel Does Not Work115
- Touch Panel Inoperative115
- Document Can Not be Fed116
- Document Double Feeding116
- Document Feeding Problems116
- Document Jam117
- Document Size Not Correctly Detected119
- Wrinkles on Documents119
- Defective Images120
- Scanned-Image Problems120
- Troubleshooting from Image Defect120
- A Communications Error Occurs125
- Fax Problems125
- No Faxes Can be Received125
- No Faxes Can be Sent125
- Data of Memory Card/Pictbridge Does Not Read126
- Memory Card/Pictbridge Does Not Function (no Response)126
- Other Problems126
- The Machine Cannot be Powered on126
- Internal Memory Errors127
- Security Function Lock Related Problems127
Touch Panel Initialization Failed94

Chapter 3 Disassembly and Assembly128

Chapter 4 Adjustments and Updating of Settings, Required after Parts Replacement255

Chapter 5 Service Functions280

Chapter 6 Circuit Diagrams and Wiring Diagrams357

Chapter 7 Periodical Maintenance362

Periodical Replacement Parts362

Appendix 1 Serial Numbering System363

Appendix 2 Deletion of User Setting Information365

A2.1 Deleting User Setting Info from the Machine365

Appendix 3 Installing the Maintenance Printer Driver366

Appendix 4 Replacement of Condenser on the Main Pcb372

Brand	Brother
Model	MFC-J2310
Category	All in One Printer
Language	English

Brother MFC-J2310 Service Manual

Table of Contents

Other manuals for Brother MFC-J2310

Questions and Answers:

Brother MFC-J2310 Specifications

Related product manuals