Confidential
v
9.33 Paper Feed Motor ............................................................................................. 3-112
9.34 Paper Feed Roller ............................................................................................ 3-115
9.35 Paper Ejection Roller ........................................................................................ 3-116
9.36 Platen ............................................................................................................... 3-118
9.37 Maintenance Unit ..............................................................................................3-119
9.38 Registration Sensor PCB ASSY ....................................................................... 3-120
9.39 Base Pad on Paper Tray ASSY ........................................................................3-124
9.40 T1 Paper Pull-in Roller .....................................................................................3-125
CHAPTER 4 ADJUSTMENTS AND UPDATING OF SETTINGS, REQUIRED AFTER
PARTS REPLACEMENT .............................................................................. 4-1
1 IF YOU REPLACE THE MAIN PCB .............................................................................. 4-1
1.1 Customize destinations (Maintenance mode 74) ................................................. 4-3
1.2 Set the CIS type (Maintenance mode 59) ............................................................ 4-3
1.3 Install the firmware (Maintenance mode 28) ........................................................ 4-3
1.4 Initialize the EEPROM parameters (Maintenance mode 01) ................................ 4-5
1.5 Restore the head calibration data (Maintenance mode 68) .................................. 4-5
1.6 Set the serial number (Maintenance mode 80) .................................................... 4-5
1.7 Restore machine information (Maintenance mode 46) ......................................... 4-8
1.8 Adjust the touch panel (Maintenance mode 78) ................................................... 4-8
1.9 Update the head property data (Maintenance mode 68) ...................................... 4-8
1.10 Acquire white level data (Maintenance mode 55) ................................................. 4-8
1.11 Adjustment of vertical print lines/software correction for inclination/corrugation/
ruled lines (Maintenance mode 65) ...................................................................... 4-8
1.12 Update the paper feeding correction values (Maintenance mode 58) .................. 4-8
1.13 Adjust margins in borderless printing (Maintenance mode 66) ............................ 4-8
1.14 Reset purge and flushing counts .......................................................................... 4-8
1.15 Write head calibration data (Maintenance mode 02) ............................................ 4-9
1.16 Check scanning and printing ................................................................................ 4-9
2 IF YOU REPLACE THE HEAD/CARRIAGE UNIT ...................................................... 4-12
2.1 Update the head property data (Maintenance mode 68) .................................... 4-13
2.2 Perform ink supply purge (Maintenance mode 76) ............................................. 4-16
2.3 Check head nozzles (Maintenance mode 09) ....................................................4-16
2.4 Adjust head inclination ........................................................................................ 4-16
2.5 Adjustment of vertical print lines/software correction for inclination/corrugation/
ruled lines (Maintenance mode 65) .................................................................... 4-18
2.6 Update paper feeding correction values (Maintenance mode 58) ...................... 4-18
2.7 Adjust margins in borderless printing (Maintenance mode 66) .......................... 4-18
2.8 Write head calibration data (Maintenance mode 02) .......................................... 4-18
To Next Page
Loading...
Need help?
General
