Brother P-touch E300 - LCD Display Settings

24
GETTING STARTED
LCD Display
畫面對比度
You can change the contrast setting of the LCD display to one of five levels (+2, +1, 0, -1, -2)
to make the screen easier to read. The default setting is “0”.
Press the 設定 key to display the setup menu, select “ 調整 ” using the or key, and
then press the 執行 or 段落更換 key.
Select “ 畫面對比度 ” using the or key and set the value using the or key.
Press the 執行 or 段落更換 key.
背光
You can change the 背光 setting either to 開 or 關 .
The display is easier to see with the 背光開 . The default setting is “ 開 ”.
Press the 設定 key to display the Setup menu, select “ 背光 ” using the or key, and
then press the 執行 or 段落更換 key.
Select “ 開 ” or “ 關 ” using the or key.
Press the 執行 or 段落更換 key.
LCD Display
1
2
3
•Press the 取消 key to return to the previous step.
• Pressing the 空格 / 轉換 key on the contrast setting screen sets the contrast to the default value “0”.
1
2
3
• Power can be saved when the 背光 is turned off.
• The 背光 will automatically turn off after 10 seconds of inactivity, press any key to re-enable it.
During printing, the 背光 is disabled.