TROUBLESHOOTING
48
Error Messages
When an error message appears on the display, follow the directions provided below.
Error Messages
Message
Cause/Remedy
請使用
專用變壓器！
An incompatible AC adapter is connected.
Use an appropriate AC adapter.
電池電量低！
The installed batteries are getting weak.
請更換電池！
The installed batteries are about to run out.
鋰電池
請充電！
The battery is low. Please charge the lithium-ion battery.
鋰電池已受損
請使用
其他電源！
The Li-ion is damaged. Please use an AC adapter or an other battery.
冷卻中
重開機前
請靜待 1 分鐘！
High temperature error.
裁刀出錯！
The tape cutter has been closed when you tried to print or feed tape.
Turn the P-touch off and then on again before continuing. When tape
is tangled in the cutter, remove the tape.
尚未安裝
標籤色帶！
There is no tape cassette installed when you try to print or preview a
label, or feed tape. Install a tape cassette before continuing.
超過最大
允許字數！
The maximum number of characters have already been entered. Edit
the text and use fewer characters.
資料未輸入！ There is no text, 符號 or 條碼 data entered when you try to print or
preview a label. Enter data before continuing.
錯誤的數值！
The value entered for setting the tape length. Enter a valid value for
the setting.
最多為 5 行！
There are already five lines of text when you press the Enter key.
Limit the number of lines to five.
最多為 3 行！
There are more than three lines of text when you press the Print or
Preview key while using 12 mm tape. Limit the number of lines to
three, or replace with a larger width tape cassette.
最多為 2 行！
There are more than two lines of text when you press the Print or
Preview key while using 9 or 6 mm tape. Limit the number of lines to
two, or replace with a larger width tape cassette.
最多為 1 行！
There is more than one line of text when you press the Print or
Preview key while using 3.5 mm tape. Limit the number of lines to
one, or replace with a larger width tape cassette.
全部段落合計
最多為 5 個！
There are already five blocks of text. Limit the number of blocks to
five.
內容長度
超過 1m 時，
無法列印！
The length of the label to be printed using the text entered is longer
than 1 m. Edit the text so that the length of the label is less than 1 m.
輸入的內容超過
標籤長度設定！
The length of the label to be printed using the text entered is longer
than the length setting. Edit the text to fit within the set length or
change the length setting.
To Next Page
Loading...
