Brother P-touch E300 - Setting 條碼 Parameters and Entering 條碼 Data; Editing and Deleting a 條碼

EDITING A LABEL
28
Creating a 條碼 Label
Setting 條碼 Parameters and Entering 條碼 Data
Press the 條碼 key.
The 條碼 Setup screen is displayed.
Select an attribute using the or key, and then set a value for that attribute using
the or key.
- 規格 : CODE39, CODE128, EAN-8, EAN-13, GS1-128 (UCC/EAN-128), UPC-A,
UPC-E, I-2/5 (ITF), CODABAR
- 寬度 : 小 , 大
- 底部文字 : 有 , 無
- 檢查碼 : 無 , 有
檢查碼 only available for Code39, I-2/5 and Codabar protocols.
Press the 執行 or 段落更換 key to apply the settings.
Type in the 條碼 data.
Special characters can be entered in the 條碼 when using the
CODE39, CODE128, CODABAR or GS1-128 protocols. When
not using special characters, go to step 7.
Press the 符號 key.
A list of characters available for the current protocol is displayed.
Select a character using the or key, then press the 執行 or 段
落更換
key to insert the character in the 條碼 data.
Press the 執行 or 段落更換 key to insert the 條碼 in the label.
The 條碼 is displayed on the text entry screen.
Editing and Deleting a 條碼
•To edit 條碼 parameters and 條碼 data, position the cursor beneath the 條碼 mark on the
data entry screen and then open the 條碼 Setup screen. Refer to “Setting 條碼 Parameters
and Entering 條碼 Data” on page 28.
• To delete a 條碼 from a label, position the cursor to the right of the 條碼 mark on the data
entry screen and press the 倒退 key.
1
Up to five 條碼 can be entered on a label.
2
Characters may not appear below the 條碼 even when “ 有 ” is selected for “ 底部文字 ”,
depending on the tape width being used, the number of lines entered, or the current character
style settings.
3
New settings are NOT applied if you do not press the 執行 or 段落更換 key.
4
5
6
To print labels refer to “LABEL PRINTING” on page 41.
7
•Press the 取消 key to return to the previous step.
•Press the 空格 / 轉換 key to set the selected attribute to the default value.
• Refer to the Bar Code Settings table for a list of all available settings.