Brother P-touch E300 - Label Printing; Label Preview; Printing Labels

1
2
3
4
5
6
7
8
9
39
 EDITING A LABEL
Setting 兩端空白
The tape 兩端空白 allow you to specify how the tape is fed and cut when printing labels. In
particular, the “ 省帶 ” option greatly reduce the amount of wasted tape by using smaller
margins and eliminating blank sections cut between labels. Depends on labelling application
type, the setting value is fixed or limited.
Press the 字形 key. The current settings are displayed.
Select “兩端空白” using the or key, and then set the value by
using the or key.
Press the 執行 or 段落更換 key to apply the settings.
Tape Cutting Options
Setting 兩端空白
1
2
3
New settings are NOT applied if you do not press the 執行 or 段落更換 key.
•Press the 取消 key to return to the previous step.
• Refer to the Tape Cutting table for a list of all available settings.
Setting Description Example
大
• Each label is printed, leaving a margin of 24 mm
on each end.
小
• A margin of 23 mm is fed before printing each
label. The printed label has a margin of 4 mm
before and after the text.
省帶
• Use this setting when printing several labels with
minimum margins.
• A margin of 23 mm is printed first, and then each
label is printed, leaving a margin of 4 mm before
and after the text.
不裁切
• Use this setting when printing Heat Shrink Tube.
• Pressing the Shift key and then the 預覽 key
feeds the last printed label and cuts it.
ABC
24 mm
24 mm
ABC
4mm
4mm
23 mm
ABC
ABC
4mm
ABC
4mm
24 mm