27
EDITING A LABEL
Creating a 條碼 Label
PATCH PANEL
Labels printed with this mode can be used to identify various types of
panels. In this mode, you can specify
段落長度
,
段落數
,
分行
,
方向
,
反轉
(
開
/
關
) and
複製
(
開
/
關
).
•
段落長度
: 15mm, 5 - 300mm
•
段落數
: 4, 1 - 50
•
分行
: Tic, Dash, Line, Bold, Frame, None
•
方向
: (Horizontal), (Vertical)
•
反轉
: 關 ,
開
•
複製
: 關 ,
開
Adjust block spacing independently when “
複製
” is set to “
開
”.
- Block #: 1, 1 - 50
-
複製
: 1.0, 1.0 - 9.5 (increment by 0.1)
PUNCH-DOWN BLOCK
Labels printed with this mode can be used to identify a type of electrical connection often
used in telephony. There are up two lines for each block on a single label and you can enter
two lines for each block. In this mode, you can specify 模組寬度 , 段落類型 , 順序類型 and 初
始值 .
• 模組寬度 : 200mm, 50 - 300mm
• 段落類型 : 4 對 , 2 對 , 3 對 , 5 對 , 空格
• 順序類型 : (None), (Horizontal), (Backbone)
• 初始值 : ---, 1 - 99999
Using the 條碼 function you can create labels with one dimensional 條碼 for use with asset
control tags, serial number labels, and even POS and stock control systems.
Selectable “ 條碼 ” are listed in the Appendix. (See page 55.)
Block lengthBlock length
Block length
• When Blank is selected in 段落類型 , 順序類型 is set to None.
• When None is selected in
順序類型
,
初始值
shows “---” and you cannot set a value.
• Horizontal or Backbone, however, allows you to set Start value from 1 to 99,999.
Creating a 條碼 Label
• The P-touch is not designed exclusively for creating 條碼 labels. Always check that 條碼 labels
can be read by the bar code reader.
• For best results, print 條碼 labels in black ink on white tape. Some bar code readers may not be
able to read 條碼 labels created using coloured tape or ink.
• Use the “Large” setting for “Width” whenever possible. Some bar code readers may not be able
to read 條碼 labels created using the “Small” setting.
• Continuously printing a large number of labels with 條碼 can overheat the print head, which
may affect printing quality.
To Next Page
Loading...
