EDITING A LABEL
40
Setting 兩端空白
Selecting how tape is fed and cut
When printing, the message “ 裁切並繼續 ” is displayed and goes into [cut pause mode].
Pressing the Tape cutter lever, you can cut the tape at the position you set in “ 兩端空白 ”.
The details are as follows.
• : Stop here and goes into [cut pause mode].
• : Stop here and finish printing.
• : Stop here and goes into [tape feed mode].
• When using 熱縮套管 , set labelling application type to “Cable Wrap” and select “ 熱縮套管 ”.
In this case, cut option if fixed to “ 不裁切 ”. After printing, remove the 熱縮套管 cassette from
the labelling system and use scissors to cut the tape.
• After printing, remove the Fabric Iron On tape cassette from the labelling system and use
scissors to cut the tape.
小 省帶
大 不裁切
When the cut option is set to No Cut or Chain, it stops in the middle of printing area after the last
label is printed. After “ 要送帶嗎 ?” is displayed, press 執行 to feed tape. Press 取消 to return to
the entering text mode.
To Next Page
Loading...
