Brother RJ-3230B - Page 147

Shows the [Select Media] screen for ten seconds after you close the Roll Compartment Cover.
- Feed
Feeds the label automatically when you close the Roll Compartment Cover.
- Auto Detect
Performs Auto Detect automatically when you close the Roll Compartment Cover. The printer displays
the detected paper size, and then displays the Ready screen.
- None
No action and no change on the LCD.
• Exit Position
Selects the media output location.
Advanced Tab
• Feed Key Function
Selects the operation performed when is pressed. If Program Settings is selected, click File and select
the command file.
• Menu Key Function
Selects the operation performed when Menu / b (Select) button is pressed. If Program Settings is selected,
click File and select the command file.
• Print Information Report
Selects the information you want to include in the printer Information Report.
• JPEG Printing Setting
Selects the method of image processing when printing JPEG images.
• Serialize Mode
Specifies the serialise (number) method for your printed labels.
• Save Printer Print Log
Selects whether to save the printer’s print log. If Disable is selected, the Save Print Log in File option
cannot be enabled.
• Print Data after Printing
Specifies whether print data is erased after printing.
• Linerless
Selects to enable support for Linerless rolls.
Print Position / Sensors Tab
When you use standard media, it is unnecessary to adjust the sensors.
• Printing Reference Point Adjustment
Adjusts the position of the reference point (point of origin for printing). This corrects printing misalignments
resulting from differences in printer models or from the fixed margins of some software.
The reference point cannot be adjusted for raster printing.
• Tear Adjust
- Adjusts the tear bar tear-off position for paper media.
NOTE
Depending on the media type, the cut position and margins may not match your settings. If this
occurs, adjust the Tear Adjust setting, and then try to print again.
- When Use Peeler Function is enabled and the peeled labels are jammed or are not ejected correctly
after printing, adjust the Tear Adjust setting, and then try to print again.
143