Level 1 Level 2 Descriptions
• Auto-detected media
• Media settings obtained using the Auto Detect function.
Auto Detect
- Automatically adjust the sensor sensitivity and detect the length of the set paper.
Specify Settings in advance.
Settings
1
- Configure the settings before performing Auto Detect.
Width
Select the paper width to be auto-detected.
Sensor Type
Select the sensor type: Die-cut, Mark, or Continuous.
Sensor
Calibr
Enable or disable sensor calibration during auto-detection.
Media
Timeout
Set the auto-detected paper to Continuous if Auto Detect does not find any
gap or black mark according to the Media Timeout length.
Energy Rank
Select the energy rank to adjust the print density.
1
Requires from the firmware version 1.09 or later.
[Settings]
Level 1
Level 2 Descriptions
Exit Position
Tear / Peeler Select the media exit method.
Language
Dansk / Deutsch / English /
Español / Français / Italiano /
Nederlands / Norsk /
Português / Suomi / Svenska / 日
本語 / 繁體中文
Select the language.
LCD Contrast
+2 / +1 / 0 / -1 / -2 Set the contrast of the LCD. The higher the number, the
stronger the contrast.
Beeper
On / Off Enable or disable the beeper.
Configuration
Check the firmware version, font version, and available
memory.
Tear Bar
Upward / Downward Adjust the tear position.
This setting appears when the Linerless is set to Off in
the Advanced tab of the Printer Setting Tool.
Cover Setting
1
Select Media
Shows the Select Media screen for ten seconds after
you close the Roll Compartment Cover.
Feed
Feeds the label automatically when you close the Roll
Compartment Cover.
Auto Detect
Performs Auto Detect automatically when you close the
Roll Compartment Cover. The printer displays the detected
paper size, and then displays the Ready screen.
None
No action and no change on the LCD.
Clock
On / Off Show or hide the clock icon on the LCD.
AutoSync Time
On / Off This setting appears when Clock is set to On.
Time Zone
Set the time zone. This setting appears when Clock is set
to On.
Date&Time
Display the date and time.
This setting appears when Clock is set to On.
1
Requires from the firmware version 1.09 or later.
158
To Next Page
Loading...
