Brother S-7300A-403P - Memory Switch Settings - Sewing Programs; Sewing Program Settings (400-499); Standard Device Settings (500-599)

S-7300A
6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)
53
Sewing program settings (400 to 499)
No. Setting range
Initial
value
Setting
units
Setting details
400
ON/OFF
OFF
－
Stopping during start backtacking and sewing speed
ON: When the treadle is returned to the neutral position, start backtacking
can be stopped before it is finished, and the speed during start
backtacking becomes the speed corresponding to the treadle
depression amount (low speed - start backtacking speed)
OFF: When the treadle is returned to the neutral position, start backtacking
ends, sewing stops and the sewing speed becomes the start
backtacking speed (constant)
401
ON/OFF
ON
－
Feed direction when sewing machine motor is stopped immediately after
start backtacking is complete
OFF: Sewing machine motor stops after start backtacking is
complete
* If MSW-400 is set to "OFF", operation occurs when the treadle
is depressed slightly.
ON: After start backtack sewing, the feed moves forward, then
the sewing machine motor stops.
402
1 - 2
1
1
Fixed stitch sewing load FUNC when stitch control in reverse direction.
1: Reverse stitch sewing when hand switch is ON
2: Fixed stitch sewing when hand switch is ON
403
300 - 4000
(sti/min)
4000
100
1st stitch sewing speed for slow start original pattern
404
300 - 4000
(sti/min)
4000
100
2nd stitch sewing speed for slow start original pattern
405
300 - 4000
(sti/min)
4000
100 3rd stitch sewing speed for slow start original pattern
406
300 - 4000
(sti/min)
4000
100 4th stitch sewing speed for slow start original pattern
407
ON/OFF
OFF
－
Synchronize with main pitch of backtack sewing pitch
ON: Synchronized
OFF: Not synchronized
Standard device settings (500 to 599)
No. Setting range
Initial
value
Setting
units
Setting details
500
OFF, 1 - 3
1
1
Presser foot lifter SW function
OFF: Disabled
1: Presser foot lifter switch
2: Puller switch (alternate)
3: Puller switch (momentary)
* Puller operation is enabled when MSW-960 is set to "1" (it does not
operate when set to other than "2" or "3").
(Refer to the Service Manual for details on MSW-960.)
* If set to puller switch, the presser foot lifting function using the switch is
disabled.