Running the minispec mq20 Toothpaste Analyzer
38 E1400912_1_001
Start the calibration and tune the gain with the sample that has the highest NMR signal
(typically the sample with the highest mass/highest concentration).
After Gain Adjustment one calibration sample after the other is analyzed. Depending on the
application one or two parameters are calibrated. It is also possible to calibrate for 2 values
simultaneously. Start with the first sample. As the Gain is fixed now, the order in which the
calibration samples are measured does not matter.
The calibration measurements are shown on the screen.
To Next Page
Loading...
