Style Programming
SMART MATRIX FEEDER 2-30
Parameters for SEAMLESS, SOCKS, PANTYHOSE, JERSEY KNIT e JACQUARD
KNIT (*)
application - ULTRAFEEDER
Set the operation parameter of device Group #1
within the STD, ADV and LFATOL windows,
operating as described on paragraph – Navigation
throughout the Display windows.
For the meaning of the individual parameters,
please refer to the ULTRAFEEDER Manual
and to the Cross Reference Table shown on
Section 3 of this manual
In the LFATOL window you may either setup or
disable (OFF) for every device group, the Learn and
Calibration Functions.
For more details about the meaning of parameters
available on LFATOL window, please refer to
Section 3.
(*) For JACQUARD KNIT application, and additional parameter
(STYLE REPEAT) appears between SYNC. UF #N and
CALIBRATION LFA; this allows you to specify a repeat factor
of your JACQUARD pattern expressed in number of PRX
pulses.
Once you have setup all the relevant parameters
inside the STD, ADV and LFATOL windows.
SAVE to save the set parameter and return to the STYLE
SECTION EDIT screen.
Select GROUP #2
To Next Page
Loading...