Buderus Logamatic 4211 - Page 57

Additional programming options
8
Logamatic 4211 - Subject to technical modifications.
57
8.1.4 Connecting heating phases
A heating phase consists of two switching points – a start and a stop point. To
connect two consecutive heating phases, place the stop point of the first heating
phase onto the start point of the next phase.
Example:
Starting from the "Midday program" for heating circuit 2, you want to join the
Monday heating phase from 11:30 to 13:00 to the heating phase 17:00 to 22:00.
In other words you want to heat continually from 11:30 until 22:00.
Your modified program will be saved under the program name "Own" and the
number of the heating circuit.
z Select a heating circuit (Æ Chapter 7.6).
Example: Heating circ. 2
z Select the standard program for the chosen heating circuit
(Æ Chapter 7.10) (here: "Midday program").
The first switching point (start point): Monday at 06:00 at 21 °C will be displayed.
Turn the rotary selector to the stop point of the first heating phase you want to
connect with another (here: "13:00").
The display shows the stop point to be connected.
AUT
Fig. 19 Connecting two heating phases
A "Midday program"
B New program "Own program 2"
1 Day mode
2 Night mode
3 Turn from 13:00 to 17:00
A
B
7 747 012 053-11.1RS
1
2
06:00
22:00
1
2
08:00
11:30
11:30
13:00
17:00
06:00
08:00
22:00
3
Midday program
21°C
at 06:00
Monday
Midday program
Monday
17°C
at 13:00