Buell 2007 FIREBOLT - Page 605

7-50 2007 Buell Firebolt: Electrical
HOME
INSTALLATION
Right Side
1. Attach throttle cables to hand control. See 2.23 THROT-
TLE CONTROL.
2. Install right switch housing.
a. Position housing on right handlebar by engaging
alignment pin on front housing with hole in handle-
bar.
b. Attach switch housing with two mounting fasteners
and tighten to 25-33 in-lbs (3-4 Nm).
3. Attach brake switch connector [121].
4. Attach right handlebar switch connector [22] to wire har-
ness.
1WARNING1WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
5. Check handlebar switch for proper operation. If operation
fails, reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to IGN.
b. Start motorcycle.
c. Turn ignition key switch to OFF.
Left Side
1. Install left switch housing.
a. Position housing on left handlebar by engaging
alignment pin on front housing with hole in handle-
bar.
b. Attach switch housing with three mounting fasteners
and tighten to 25-33 in-lbs (3-4 Nm).
2. Connect clutch switch [95].
3. Attach right handlebar switch connector [24] to wire har-
ness.
1WARNING1WARNING
Be sure that all lights and switches operate properly
before operating motorcycle. Low visibility of rider can
result in death or serious injury. (00316a)
4. Check handlebar switch for proper operation. If operation
fails, reread procedure and verify that all steps were per-
formed.
a. Turn ignition key switch to ON.
b. Check headlight LOW and HIGH beam settings.
c. Set headlight to LOW beam. Press passing lamp
switch. Headlight should flash HIGH beam for as
long as the switch is pressed.
d. Check left and right turn signals.
e. Activate horn by pressing horn switch.
5. Turn ignition key switch to OFF.
Figure 7-58. Left Handlebar Switch Connection
2
8
7
6
5
4
3
1
2
1
b1103x7x
Clutch Switch [95]
Left Handlebar Switch [24]
Y/BK
Low/Unused
BE/W
Y/BK
V/BN
Light power
High beam
Horn
From flasher
Left turn
Right turn
Horn power
To interlock circuit
To ground
Y
WW
—
V
O
V
O
BN BN
BE
BE
BK
TN/LTGN