7-68 2007 Buell Firebolt: Electrical
HOME
INTERACTIVE EXHAUST HARNESS (XB12 MODELS) 7.24
REMOVAL
1. Remove seat and pillion. See 2.38 SEAT.
2. Remove intake cover assembly. See 2.34 INTAKE
COVER ASSEMBLY.
3. Remove negative battery cable from battery.
4. Remove main battery ground and the exhaust actuator
ground.
5. Remove the subframe tail body work. See 2.36 SUB-
FRAME TAIL ASSEMBLY AND BODY WORK.
6. See Figure 7-84. Separate exhaust actuator harness
connector [165] (2) at main harness.
7. Note location of cable strap and cut as required.
8. Pull actuator harness through frame.
9. Disconnect connector [161B] from actuator.
NOTE
For actuator and actuator cable replacement see 7.6 INTER-
ACTIVE EXHAUST SYSTEM (XB12 MODEL).
Figure 7-84. Left Side Subframe Hose and Wire Routing
Figure 2-85. Battery and Harness Ground
(battery removed for clarity)
8463
1. Fuel vent hose
2. Main wire harness
3. Cable strap
4. Rear shock reservoir hose
5. Main wire harness connection [165]
1
2
3
5
4
8478
1. Main battery ground
2. Wire harness ground
3. Main fuse case
1
2
3
To Next Page
Loading...
