Throw sifter Safety 7
© Copyright 2018 Bühler AG DFTA-66620-2-en-1803
1.4 Connecting to the electrical mains
• Observe the regulations of the local safety authorities.
• The power supply must be fuse-protected in accordance with locally applicable
codes and regulations.
• Check that the operating voltage and frequency correspond to the specifications
provided on the identification plate and in the control cabinet.
• The electrical wiring to the control system must be connected according to the
wiring diagram to ensure that the phase conductors are really switched in the
case of single-phase power supplies.
1.5 Safety concept
The machine is normally part of an installation, and therefore has to be integrated
into the safety concept of the installation.
1.6 Spare and wear parts
Only original spare and wear parts may be used.
If this is not complied with, safe operation is no longer guaranteed, particularly if the
machine is used in an Ex zone.
To Next Page
Loading...
