24
Installation and wiring
→ Mount the device into the fitting, as shown in Fig. 11:
A
→ Check that seal "A" is set on the fitting and that it is not
damaged. Replace the seal if necessary.
→ Carefully insert the device into the fitting.
→ Position the device in such a way that the markings located
on either side of the electronics box are parallel to the pipe.
→ Tighten the nut on the fitting.
Fig. 11 : Installation of the device in a fitting
→ Wire the device according to instructions in chpt. 8.3.
English
Type 8222 ELEMENT
To Next Page
Loading...
