YAK 130
BVM ©2016 15 Mar. 23, 2016
Alternate Method for Gluing Inlets
NOTE: The Aft ends of the Inlet Duct are held together with #64 rubber bands.
For a permanent bonding of the (2) Inlet
Ducts, Use Aeropoxy. .
Inject a small amount between the aft center
flanges of the duct..
Apply to bottom, center span, and top
junctions. Wipe excess away.
Hold together for cure with clothes pins or
plastic clamps.
Remove the rubber bands.
To Next Page
Loading...
